How do you remove the Fit valve cover?
Follow the procedure below. If in doubt, check the video at the bottom of the page and leave your comment on YouTube.
Good luck and happy maintenance!
Before removing the valve cover, a few earlier steps must be completed:
- Remove the air filter box assembly
- Disconnect the throttle cable from the TBI/throttle body
Once this is done, carry out the following steps
1. Remove the 8 10mm bolts holding the valve cover (when reinstalling, tighten to 12Nm/1.2Kgf.m as shown in the video)
2. Remove the valve cover from the cylinder head
3. The procedure is complete; reinstall as needed.
************************************
See more details in the Fit maintenance video at the exact point in the procedure:
https://youtu.be/7ECtYwQBwmo?t=8
Paulo's Garage · Informational content based on hands-on garage experience. Always refer to your car's official service manual and seek professional assistance when in doubt.