How do you remove the ignition coils from a Honda Fit with a 1.4 engine?
Follow the procedure below. If in doubt, check the video at the bottom of the page and leave your comment on YouTube.
Good luck and happy maintenance!
To remove the ignition coils, the first step is to remove the engine cover.
Front ignition coils:
1. Disconnect the ignition coil connector. Just press the back of the connector and you will see the tab rise at the front and release from the lock. With the connector unlocked, pull it out of the ignition coil, always holding and pulling the connector, never the wires.
2. Loosen the 10mm bolt.
3. Pull the ignition coil upward. You may need to turn it slightly from side to side to help it come out.
Rear ignition coils
4. Release the wiring harness holder. First lift the plastic lock and push the wiring harness holder toward the firewall.
5. Pull the wiring harness holder out of its clip near the engine pulleys, toward the battery.
6. Disconnect the ignition coil connectors using the same procedure as in step 1.
7. Loosen and remove the 10mm bolts
8. Pull the ignition coil upward. You may need to turn it slightly from side to side to help it come out.
*****
Reassembly is the reverse process; the ignition coil bolts are tightened to 10Nm (1Kgf.m)
9. This completes the procedure; reinstall as needed.